|
HN55 INSTALLATION CAN ALSO BE INSTALLED AS... 
 Starting the Unit
1. Be sure chemical pump is locked into the bottom of the water motor. (1/4 turn to the right)
2. Open valves (B) and (C)
3. Close valve (A)
4. Open air vent until all trapped air is released
Stopping the Unit
1. Open valve (A), then close valves (B) and (C)
For a printable version of the diagrams... click here
Alternate mounting below pipe
 NOTE: Do not hook water motor up backward. Water must flow through motor from right to left. If necessary, crisscross hoses to accommodate setup.
TOP OF PAGE
|